Microcontroller and Microprocessor (500-mcq) series
notic-अगर आपको word पढ़ने मे problem आ रही है तो desktop mode कर के पढ़े
PAGE-1
Q-Why microcontrollers are not called general purpose computers?
a) because they have built in RAM and ROM
b) because they design to perform dedicated task
c) because they are cheap
d) because they consume low power
………….
Answer: b
Explanation: Microcontrollers are designed to perform dedicated tasks. While designing general purpose computers end use is not known to designers.
Q-Abbreviate CISC and RISC.
a) Complete Instruction Set Computer, Reduced Instruction Set Computer
b) Complex Instruction Set Computer, Reduced Instruction Set Computer
c) Complex Instruction Set Computer, Reliable Instruction Set Computer
d) Complete Instruction Set Computer, Reliable Instruction Set Computer
…………
Answer: b
Explanation: CISC means Complete Instruction Set Computer because in this a microcontroller has an instruction set that supports many addressing modes for the arithmetic and logical instructions, data transfer and memory accesses instructions. RISC means Reduced Instruction Set Computer because here a microcontroller has an instruction set that supports fewer addressing modes for the arithmetic and logical instructions and for data transfer instructions.
Q-If we say microcontroller is 8-bit then here 8-bit denotes size of:
a) Data Bus
b) ALU
c) Control Bus
d) Address Bus
………….
Answer: b
Explanation: If we say a microcontroller is 8-bit it means that it is capable of processing 8-bit data at a time. Data processing is the task of ALU and if ALU is able to process 8-bit data then the data bus should be 8-bit wide. In most books it tells that size of data bus but to be precise it is the size of ALU because in Harvard Architecture there are two sets of data bus which can be of same size but it is not mandatory.
Q-What is the order decided by a processor or the CPU of a controller to execute an instruction?
a) decode,fetch,execute
b) execute,fetch,decode
c) fetch,execute,decode
d) fetch,decode,execute
………..
Explanation: First instruction is fetched from Program Memory. After fetching, instruction is decoded to generate control signals to perform the intended task. After decoding, instruction is executed and the complete intended task of that particular instruction.
a) high power dissipation
b) low power consumption
c) low voltage consumption
d) low current consumption
Explanation: Micro Controllers are made by using the concept of VLSI technology. So here, CMOS based logic gates are coupled together by this technique that consumes low power.